DIY Carbon Fiber

3right · 06-28-2011, 02:55 PM

Has anyone had their parts "dipped" ? I think some people call it Hydro printing.

I was looking at getting some parts dipped in Carbon Fiber design.

Or what about this DIY dipping kit - [Only registered can see links. ] - anyone know much about that?

3right · 08-19-2011, 02:54 PM

Anyone..........

Burke_78 · 08-19-2011, 09:39 PM

Hydrographics... I saw them do it on American Chopper once.

I don't know what all is involved but I do know a guy that can get it done

Demon Industries (Morgan Russell)
520-405-0335

06-28-2011, 02:55 PM	#1
3right Join Date: Jun 2011 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	DIY Carbon Fiber Has anyone had their parts "dipped" ? I think some people call it Hydro printing. I was looking at getting some parts dipped in Carbon Fiber design. Or what about this DIY dipping kit - [Only registered can see links. ] - anyone know much about that?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-19-2011, 02:54 PM	#2
3right Join Date: Jun 2011 Posts: 2 Thanks: 0 Thanked 0 Times in 0 Posts	Anyone..........

08-19-2011, 09:39 PM	#3
Burke_78 Join Date: Jun 2011 Posts: 62 Thanks: 0 Thanked 4 Times in 4 Posts	Hydrographics... I saw them do it on American Chopper once. I don't know what all is involved but I do know a guy that can get it done Demon Industries (Morgan Russell) 520-405-0335

Remove Advertisements Sponsored Links
YamahaForum.com Advertisement